Section 6 OTHER CONVENIENT FUNCTIONS
6-82
Manually selecting the size of the originals
This procedure allow you to select the size of the originals
manually using the touch panel.
1
Press the “Edit” key. Then, in the resulting screen, press
the “Select orig. size” [“Select size orig.”] key.
The “Select orig. size” [“Select size original”] screen will be
displayed.
Inch specifications
Metric specifications
2
If you want the size of the originals to be detected
automatically, press the “Auto” key. If you want to select a
standard original size, press the key that corresponds to the
desired size.
If you want to select a standard size other than those
displayed, press the “Other stand.Size” [“Others
stand.Size”] key.
If you want to select the dimensions of the originals
manually, press the “Input size” key and then set the
corresponding dimensions.
Inch specifications
Metric specifications
3
Press the “Close” key.
The touch panel will return to the screen in step 1.
Selecting the repeat copy mode
This procedure allow you to select the repeat copy mode so that you
can make any necessary number of additional copies later.
1
Press the “Edit” key. Then, in the resulting screen, press
the “Modify Copy” key.
The “Modify Copy” screen will be displayed.
Inch specifications
Metric specifications
NOTES
• To make additional copies with the repeat copy mode,
refer to “Printing out with the repeat copy mode”
on page 6-50.
• The setting in regard to whether or not to use the
repeat copy mode can only be made in the first step of
the job build mode and will apply to all steps in the copy
job.
!"
#$ %
&
'("" (""
) ) *
+"
,
-
"
(
#
+.
,
!"
# $% &
'
()"" )""
* * +
,
,"
-
"
)
.
,/
. #"
! "
#
$
! "
! "
! "
%%!%&'
(
%
) !%%'
%%!(
%
) '
*
+
%
) !(
%
) '
(
%
) !+
%
) '
(
%
) !%,'
*,
*,
%%!%+'
!"
#$
%&
%'
%'
%
%
%(
'
%
(
(
)
*
+
,
**-
**)
*
+
,
-
***-
!"
#$ %
&
'("" (""
) ) *
+"
,
-
"
(
#
+.
,
!"
# $% &
'
()"" )""
* * +
,
,"
-
"
)
.
,/
. #"
To Next Page
Loading...
