Section 7 COPIER MANAGEMENT
7-72
Eco print mode ON/OFF
Perform the following procedure to determine whether or not the
eco print mode will be the default setting in the initial mode.
1
Display the “Copy default” screen.
(See “Accessing the copy default settings” on
page 7-66.)
Inch specifications
Metric specifications
2
Select “Eco Print” under the “Default menu” column on the
left side of the touch panel and then press the “Change #”
key.
The “Eco Print” screen will be displayed.
Inch specifications
Metric specifications
3
Press the “On” key if you want to make the eco print mode
the default setting in the initial mode.
Inch specifications
Metric specifications
NOTE
If you want to quit the displayed setting without changing
it, press the “Back” key. The touch panel will return to the
screen in step 2.
4
Press the “Close” key.
The touch panel will return to the screen in step 2.
5
Press the “Close” key once again.
The touch panel will return to the “Default setting” screen.
6
Press the “End” key.
The touch panel will return to the contents of the “Basic”
tab.
!
!
!"
#
#
$
!"#
$
$
%
To Next Page
Loading...
