Section 7 COPIER MANAGEMENT
7-76
Default drawer[cassette]
Perform the following procedure to set one drawer[cassette] that
will be selected automatically regardless of the size of paper loaded
in that drawer[cassette]. It is NOT possible to select the
multi-bypass tray as the default drawer[cassette].
1
Display the “Copy default” screen.
(See “Accessing the copy default settings” on
page 7-66.)
Inch specifications
Metric specifications
2
Select “Default drawer[cassette]” under the “Default menu”
column on the left side of the touch panel and then press
the “Change #” key.
The “Default drawer[cassette]” screen will be displayed.
Inch specifications
Metric specifications
3
Press the key that corresponds to the desired
drawer[cassette].
Inch specifications
Metric specifications
NOTES
• If you want to quit the displayed setting without
changing it, press the “Back” key. The touch panel will
return to the screen in step 2.
• The setting for drawer[cassette] No.1 will not be
available on duplex copiers because the Duplex Unit is
installed in its place.
• The setting for drawer[cassette] No.3 and No.4 will only
be available when the optional Paper Feeder is
installed on your copier.
4
Press the “Close” key.
The touch panel will return to the screen in step 2.
5
Press the “Close” key once again.
The touch panel will return to the “Default setting” screen.
6
Press the “End” key.
The touch panel will return to the contents of the “Basic”
tab.
!
!
!"
#
#
$
!"#
$
$
%
To Next Page
Loading...
