Section 7 COPIER MANAGEMENT
7-78
Default magnification ratio
Perform the following procedure to set whether or not the
appropriate magnification ratio to be calculated automatically
when you select the size of copy paper.
1
Display the “Copy default” screen.
(See “Accessing the copy default settings” on
page 7-66.)
Inch specifications
Metric specifications
2
Select “Default magnification” [“Default mode”] under the
“Default menu” column on the left side of the touch panel
and then press the “Change #” key.
The “Default magnification” [“Default mode”] screen will be
displayed.
Inch specifications
Metric specifications
3
Press the “Manual” key or the “AMS” key, as appropriate.
Inch specifications
Metric specifications
NOTE
If you want to quit the displayed setting without changing
it, press the “Back” key. The touch panel will return to the
screen in step 2.
4
Press the “Close” key.
The touch panel will return to the screen in step 2.
5
Press the “Close” key once again.
The touch panel will return to the “Default setting” screen.
6
Press the “End” key.
The touch panel will return to the contents of the “Basic”
tab.
!
!
!"#
$%
&
'
!"#
$%
&
'
To Next Page
Loading...
