2-5
Daily Management and Maintenance > Improving and maintaining of print quality
changing the lower limit temperature for print
1
[Home] key > [...] > [Professional Settings] > [U735 Set Ink
Temperature Control] > [02 Lower]
2
Change the temperature using [+] or [-]
The range of the lower limit temperature is as follows.
3
[Start] key > [Stop] key > [Close]
The professional settings close.
Aligning the Leading Edge
The leading edge of the paper and print image automatically adjusts the print start position of the image to the paper size
calculated from the paper outline read by the conveying CIS. The start position may need to be adjusted because it
varies depending on the type of paper, size, paper source, and print mode.
Align the leading edge timing of the document and the printed image by adjusting the amount of change that moves the
image in the leading edge direction when viewed from the transport direction
1
[Home] key > [...] > [Professional Settings] > [U034 Adjust
Paper Timing Data] > [Start Position]
2
Select the print speed.
Select the print speed (conditions) according to the paper source, paper size, paper type, and
printer driver settings used for printing.
Item Range Default Amount of change
02 Lower +0.0 to 28.0 22 0.1
Item Contents
Full(Shift) Select this item to print from Cassette 1 to 8.
Full Select this item under the following conditions.
• Paper source: machine’s MP Tray and optional MP
Tray
•[Main Unit Paper Feed Speed] is set to [Low].
•[Media Type]: Inkjet matte paper
•Set [Inkjet Matte Paper Action] to [High Print
Coverage Mode].
"Chapter 15 Setting up from System Menu" of
Operation Guide
To Next Page
Loading...
