EasyManuals Logo

Leaf Aptus-II Installation Guide

Leaf Aptus-II
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
Installation Procedures 57
Removing the Leaf Digital Camera Back From the Camera Body
1. Place the camera on a flat, steady surface.
2. If any of the following cables are connected, disconnect them:
FireWire cable
Camera-to-Back Sync cable
Flash Sync cable
3. Slide the Release button to the right side.
Figure 9: Removing the Leaf Aptus digital camera back from a Hasselblad
camera
4.
Tilt the digital camera back away from the camera body, and then
remove it.
Release Button

Table of Contents

Other manuals for Leaf Aptus-II

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Leaf Aptus-II and is the answer not in the manual?

Leaf Aptus-II Specifications

General IconGeneral
BrandLeaf
ModelAptus-II
CategoryCamera Accessories
LanguageEnglish