Leaf Aptus-II Installation Guide

88 Chapter 9 – Mamiya RZ67/RZ67ProII/ RZ67ProIID
Figure 8: Connecting a Flash Sync Cable to Leaf Aptus
Connecting the FireWire Cable
For information about connecting the FireWire cable, see Chapter 11,
Working in Tethered Mode.
Removing the Leaf Digital Camera Back From the Camera Body
1. Place the camera on a steady, flat surface.
2. If any of the following cables are connected, disconnect them:
• FireWire cable
• Camera Control cable
• Camera-to-Back Sync cable
• Flash Sync cable
3. Slide and press the Release button on the digital camera back to the
left side.

Leaf Aptus-II Specifications

General

Brand	Leaf
Model	Aptus-II
Category	Camera Accessories
Language	English