40 Chapter 5 – Hasselblad H1
Before Getting Started
This chapter describes the Leaf Aptus digital camera back installation for
the Hasselblad H1 camera.
Items Required for the Installation
For a detailed list of the items required for installation, see Items Required
for the Installation on page 6. In addition to the items shown, the
Hasselblad H1digital camera back kit also includes the Hasselblad H1
mount. You will need the mount for the installation procedure.
Quick Installation Reference
1. Install the focusing screen.
2. Remove the protective cover from the camera back and mount the
back onto the camera body.
If you are working in tethered mode, go
straight to step 4.
3. Install the compact flash card. The installation is complete.
Working in tethered mode:
4. Install the Leaf Capture application from the CD and start the
application.
5. Connect the FireWire cable between the computer and Leaf Aptus.
After you connect the cable, the application automatically connects to
Leaf Aptus. When the connection is established, the LED indicator on
the digital camera back turns from orange to green.
Important: To avoid installation and operation problems, use only the
accessories supplied in the Leaf digital camera back kit.
Note: If you want to work with an external flash or strobe, connect the Flash
Sync cable between the camera and the flash or strobe unit.
To Next Page
Loading...
Need help?
General
