Leaf Aptus-II Installation Guide

Installation Procedures 77
Connecting the FireWire Cable
For information about connecting the FireWire cable, see Chapter 11,
Working in Tethered Mode.
Removing the Leaf Digital Camera Back from the Camera Body
1. Place the camera on a solid, steady surface.
2. If any of the following cables are connected, disconnect them:
• FireWire cable
• Camera-to-Back Sync cable
• Flash Sync cable
3. Slide the Release button to the right side.
Figure 8: Removing the Leaf Aptus digital camera back from a Mamiya RB
camera
4.
Tilt the camera back away from the camera body to remove it.
Release Button

Leaf Aptus-II Specifications

General

Brand	Leaf
Model	Aptus-II
Category	Camera Accessories
Language	English