LeeBoy 8616 - Changing the Engine Lubrication Oil Filter; Fuel System; Fuel Tank

7-20 LeeBoy Model 8616 Conveyor Paver
Maintenance
Fuel system
Fuel Tank
The fuel level is indicated on the digital display FUEL
gauge and indicates the amount of fuel in the tank. Fill
the fuel tank FULL..
To fill fuel tank:
Fill the tank to FULL before the paver
is stored for the night to reduce the accumulation of
moisture in the tank from condensation.
The operator must be off of the paver
while fuel is added. No smoking while lling the fuel
tank. All fuels for internal combustion engines are
ammable. Fill the fuel tank only in a designated
area with good ventilation. Have a re extinguisher
available.
Explosion Hazard! Never ll the tank
near an open ame, or near equipment that can
create sparks. Never check fuel level or check for
fuel leaks with an open ame.
1. Stop engine.
2. Remove cap from fuel tank.
NOTE: Use only DIESEL FUEL.
3. Fill with diesel fuel till FULL. Replace cap.
Changing The Engine
Lubrication Oil Filter
The engine lubrication oil lter must be changed when
the engine lubrication oil is changed.
Do not change the engine lubrication
oil when the engine and lubrication oil are hot.
Change when warm only. Hot oil can cause serious
personal injury.
Do not change the engine lubrication
oil lter with the engine running. Serious engine
damage, or failure, will occur.
With the engine “stopped” and lled with new engine
lubrication oil, proceed as follows:
1. Wipe the area around the engine lubrication oil lter
element and its mounting base, with a clean cloth.
2. Place a container under the lter element.
3. Use a lter removal wrench to loosen and remove
the lter element by turning it in a counterclockwise
(CCW) direction of rotation. Drain and discard the
removed lter element.
NOTE: Be sure the used rubber gasket is removed and
discarded with the lter element.
4. Wipe the inside area of the lubrication oil lter head
using a clean lint free cloth.
5. Put clean engine lubrication oil on the rubber gasket
area of the new lter element. Fill the new lter
element with correct, new, and clean oil.
6. Install the new lter element onto the lter head.
Carefully tighten the lter element, by hand only.
NOTE: Tighten the lter element as directed on the lter
element, by the lter manufacturer.
Return to
Last Viewed
Return to
Thumb Index