7-34 LeeBoy Model 8616 Conveyor Paver
Maintenance
Safety Label Installation
Anytime the LeeBoy Model 8616 Conveyor Paver has
been repainted or the safety labels have been removed,
damaged or can’t be read, a new set of labels should be
ordered and reinstalled for safe operation (see Safety
Label Locations in Section 2).
1. Be sure that the installation area is clean and dry.
Use hot soapy water and dry the area thoroughly
before installing decals.
2. Determine the exact position by taking
measurements and test tting before you remove
the backing paper.
3. For decals with no top protection paper,
determine the decal location and remove the
smallest portion of the split backing paper.
4. Align the decal over the specied area and
carefully press the small portion with the exposed
adhesive backing into place.
5. Peel back the remaining paper and carefully
smooth the remaining portion of the decal in place.
6. Small air pockets can be pierced with a pin
and smoothed out using the piece of decal backing
paper.
7. If the decal has a protective top paper, use
hot soapy water on the surface to which the decal
is being applied. Leave wet. After determining the
location, remove the backing paper and soak the
decal in clean soapy water before application. This
will help prevent air bubbles in the nished decal.
8. Smooth the decal into place with a sponge and
check for air bubbles. Small air pockets may be
pierced with a pin and smoothed out. When the
decal is completely smoothed out, carefully remove
the top paper.
Return to
Last Viewed
Return to
Thumb Index
To Next Page
Loading...
