4
LeeBoy Model 8616 Conveyor Paver 4-13
Dash Size Torque
mm ft-lb
1/16 Inch Min Max
-2 7 9
-4 11 18
-6 19 28
-8 30 36
-10 37 44
-12 50 60
-16 79 95
-20 127 152
-24 167 190
-32 262 314
Termination
Type
Dash Size Flats
1/16 Inch
JIC 4
1.5 - 1.75
JIC 6 1.0 - 1.5
JIC 8 1.5 - 1.75
JIC 10 1.0 - 1.5
JIC 12 1.0 - 1.5
JIC 16 .75 - 1.0
JIC 20 .75 - 1.0
JIC 24 .75 - 1.0
JIC 32 .75 - 1.0
JIS 4 .5 - 1.5
1. Seal faces must be in contact and the tting fully
hand tightened before marking ats.
2. Flats method is most accurate for the rst
assembly cycle, for multiple disassembly/
assembly cycles torque values are more reliable.
3. Tightening 2 ats or more is analogous to sever
over torque and may damage seal faces.
After hand tight rotate nut one full turn (8 ats)
Dash Size Max Torque
1/16 Inch ft-lb
-2 20
-4 25
-6 35
-8 45
-12 55
-16 65
-20 80
-24 95
-32 120
1. The torque values obtained from tightening pipe
threads can vary considerably depending on
thread condition. Adequate sealing can occur at
values much lower than the maximum values listed
above. Only enough torque to achieve adequate
sealing should be used.
2. When using a male tapered pipe thread with a
female straight or parallel pipe thread, maximum
values are 50% of those listed in the table.
3. If thread sealant is used, maximum values shown
should be decreased by 25%.
To Next Page
Loading...
