7
LeeBoy Model 8616 Conveyor Paver 7-5
Maintenance
Lubrication Points
Figure 7-2
Table 7-2. Lubrication Points Schedule
ITEM NO. TYPE LUB DESCRIPTION AND LOCATION INTERVAL
Legend
A Grease With Shell Avania EP Grease 2 Or Equivalent
B Spray With An Approved Release Agent or Chain Lube
1 A Auger, grease tting on end mount (end of day) Daily
2 A Conveyor Chain, left and right side Daily
3 B Conveyor and Auger Daily
4 B Auger Chain, middle of paver Daily
5 B Screed Extensions, left and right (clean surface) Daily
6 B Tracks, between track pads Weekly
7 B Cutoff Pivot at Augers Daily
8 B Spray any part of paver that contacts asphalt Daily
9 A / B Screed Crown, on chain Weekly
10 A Depth Screw (grease rst in lock position, unlock and turn 180° and grease) Weekly
11 A Main Flight Screws Ball Socket and Nut Weekly
12 A All Screws on Extension and Bearing Weekly
13 A V Grease Slides Weekly
14 A Tilt Screws Weekly
15 A Screed Pivot Weekly
16 A Slope Cylinder Pivot Weekly
17 A Grease Fitting on Rear Auger Bearings 250 Hrs
18 A Idle Oil, check level Daily
19 B Front and Rear Conveyor Idler and Drive Tubes (Not Shown) Monthly
Return to
Last Viewed
Return to
Thumb Index
To Next Page
Loading...
