LeeBoy LB Performance CB95 - Storage Precautions; Maintenance Precautions

• Drive the machine with care. Make sure speed is
compatible with conditions. Use caution on rough
ground, slopes, in trafc zones and while turning.
• Be alert for hazards and obstructions such as ditches,
trees, cliffs, overhead power lines, and areas where
there is danger of a slide.
• Be aware of and understand the job site trafc ow
patterns.
• Obey agmen, road signs, and signals.
• Watch for bystanders. Never allow anyone to be
under the machine during operation. Never allow
anyone to reach into the machine during use.
• Operator must know how to use signaling devices and
understand which circumstances require use of each
signal. Use tail lights, slow moving vehicle signs, and
warning beacon as needed when traveling on public
roads. It is recommended that you provide an escort
on the road.
• DO NOT tow the machine, except to remove from road
or load on a trailer for transport.
Storage PrecautionsStorage Precautions
• Store machine in an area away from human activity.
• DO NOT permit children to play on or around the
machine. Serious injury or death can occur from
improper/unauthorized use of the machine.
• Make sure the unit is stored on a surface that is rm,
level, and free of debris.
• Store the machine inside a building or cover securely
with a weatherproof tarpaulin.
Maintenance PrecautionsMaintenance Precautions
• DO NOT attempt repairs unless trained to do so.
Refer to manuals and experienced repair personnel
for help.
• Before working on the machine, securely block the
machine and any components that may fall. Block
any working components to prevent unexpected
movement while repairs are being made.
• Always wear safety glasses and other required safety
equipment when servicing or making repairs.
• Disconnect battery before working on the electrical
system.
• Avoid lubrication or mechanical adjustments while the
machine is in motion and engine is operating.
• If lubrication or mechanical adjustment is necessary,
use extreme caution.
• Never make repairs on pressurized components such
as uid lines, the gas system, or mechanical items until
the pressure has been relieved.
• When servicing or replacing hardened pins, use a
brass drift or other suitable material between the
hammer and pin.
• Keep brake and steering systems in good operating
condition.
11
Safety
LB Performance CB95 Broom 1-9