LeeBoy LB Performance CB95 - Change Tires

55
Maintenance
LB Performance CB95 Broom 5-23
Table 5-3.Tire Wear Chart
WEAR PATTERN CAUSE ACTION
Center
Wear
Over
Ination
Deate tire to
correct load
level.
Edge
Wear
Under
Ination
Inate tire to
correct load
level.
Side
Wear
Loss of
camber or
overloading.
Get align-
ment. Ensure
load doesn’t
exceed axle
rating.
Toe
Wear
Incorrect
toe-in.
Get alignment
service.
Cupping
Wheels out
of balance.
Check balance
and bearing
adjustment.
Flat
Spots
Wheels
locked and
tire skidding.
Adjust brakes.
Change TiresChange Tires
It is recommended that you use a
hydraulic lift if available when raising the vehicle.
Otherwise, use jack stands on a solid, at surface
to prevent the machine from tipping when it is
raised. Block the remaining wheels using sturdy
wheel chocks. DO NOT lie under the machine while
supported only by a jack. Death or serious injury can
result from improperly supporting a raised machine.
To replace the tires:
1. Loosen lug nuts.
2. Release any air that remains in the tire.
3. Use a jack or hoist to lift the side of the machine.
4. Place supports under the machine.
5. Attach a sling or other support to the tire.
6. Remove the six (6) lug nuts from the wheel.
7. Release any air that remains in the tire.
8. Using standard tire removal tools, remove the tire
from the wheel.
9. Install new tire on the wheel.
10. Measure PSI using tire pressure gauge and inate
to the proper PSI.
11. Align the mounting holes with the studs on the hub.
12. Reinstall lug nuts (6), tightening every other lug nut
alternately in a star pattern.
13. Torque to 80 ft lbs.
14. Remove supports and lower jack.