10. Turn off the engine and remove key.
11. Fasten chains (or cables) to the broom frame using
the four D-Ring tie-downs located on each side of
the frame front and rear. (Figure 4-21)
• Be careful you do not place chains or cables
over the broom’s hoses or electrical harnesses.
Fasten chain or cable only to the D-Rings on the
frame.
To prevent the broom from breaking
loose and being damaged in transport, ensure it is
properly secured to the transport trailer.
Figure 4-21. D-Ring Tie Down
12. Cover the exhaust opening with heavy gauge plastic
to prevent dust and moisture from entering the
engine.
13. After transporting the machine, be sure to remove
the plastic before operating.
OPTIONS
BrushesBrushes
Brush options are 7.6-feet or 8-feet that feature Poly/
Steel Tube, Poly Wafer, or Poly/Steel Water brushes.
Contact your authorized LeeBoy dealer for purchase.
Figure 4-22. Brush Replacement Options
Front Windshield Washer and Front Windshield Washer and
Rear Wiper/WasherRear Wiper/Washer
The front windshield wiper is standard, but the
windshield washer is optional. A rear wiper with
washer assembly is also an available option. See your
authorized dealer for these options.
Rearview Camera SystemRearview Camera System
A rearview camera system is also an available option.
(Figure 4-23) This additional safety feature assists
operators when moving in reverse by using the rear
camera to see directly behind the machine.
Figure 4-23. Rearview Camera
Operation
LB Performance CB95 Broom4-16
To Next Page
Loading...
