LeeBoy LB Performance CB95 - Every 250 Hours or Quarterly Routine Maintenance; Every 500 Hours or Semi-Annual Routine Maintenance; Every 1000 Hours or Annual Routine Maintenance; Machine Lubrication

55
Maintenance
LB Performance CB95 Broom 5-5
Every 250 Hours or Quarterly Every 250 Hours or Quarterly
Routine MaintenanceRoutine Maintenance
1. Clean hydraulic oil strainer. (Page 5-19)
2. Change the hydraulic oil and charge lter. (Page
5-18)
3. Perform previous routine maintenance and any
other engine preventive maintenance described in
the Engine Operator’s Manual.
Every 500 Hours or Semi-Annual Every 500 Hours or Semi-Annual
Routine MaintenanceRoutine Maintenance
1. Drain and replace coolant.
2. Change engine oil and lter. (Page 5-10)
3. Replace fuel lter. (Page 5-12)
4. Check and drain fuel water separator. (Page 5-13)
Replace lter if needed.
5. Perform previous routine maintenance and any
other engine preventive maintenance described in
the Engine Operator’s Manual.
Every 1000 Hours or Annual Every 1000 Hours or Annual
Routine MaintenanceRoutine Maintenance
1. Replace strainer in the hydraulic tank. (Page 5-19)
2. Replace drive axle oil. (Page 5-25)
3. Repack front wheel bearings. (Page 5-24)
4. Perform previous routine maintenance and any
other engine preventive maintenance described in
the Engine Operator’s Manual.
MACHINE LUBRICATION
Proper lubrication is necessary to maintain the machine
at top efciency. Use a high-quality multi-purpose
grease for optimum performance.
(See the following pages for lubrication points.)
Be sure to grease the brush core shaft bearing and lift
pivot daily.
It is important to grease the king pin bushings, tie rod
ends, steering cylinder rod and steering axle pivot bush-
ings every 100 hours of service.
Use jack stands on a solid, at surface
to prevent the machine from tipping when it is
raised. Block the remaining wheels using sturdy
wheel chocks. DO NOT lie under the broom while
supported only by a jack. Death or serious injury can
result from improperly supporting a raised machine.
Use the following procedure for lubricating these
components:
1. Locate and clean the single grease tting at each of
the lubrication points.
2. Apply one shot of grease to each tting with a
manual (hand) grease gun.
3. Wipe away any excess grease.