LeeBoy LB Performance CB95 - Routine Maintenance; Preparing Machine for Maintenance; Every 10 Hours or Daily Routine Maintenance; Every 50 Hours or Weekly Routine Maintenance

Maintenance
LB Performance CB95 Broom5-4
ROUTINE MAINTENANCE
Preparing Machine for Preparing Machine for
MaintenanceMaintenance
1. Park the machine on a at surface.
2. Engage the parking brake.
3. Turn off the broom drive.
4. Run engine at half-speed for three to ve minutes,
then reduce engine speed to a slow idle.
5. Lock brush in the UP position using the brush
cylinder lock as shown below in Figure 5-1. To lock,
move lock arm up as shown.
Cylinder
Lock
Figure 5-1. Cylinder Lock
6. Place ignition switch in the OFF position.
If any maintenance must be
performed while the engine is running, DO NOT leave
the machine unattended.
Every 10 Hours or Daily Routine Every 10 Hours or Daily Routine
Maintenance Maintenance
1. Lubricate the required parts. (Pages 5-6 to 5-8)
2. Check battery cables and connections. (Page
5-13)
3. Check coolant level. Fill if needed.
4. Check for indications of oil leakage. Check for
loose, worn or damaged hoses, tubes and clamps.
Tighten, repair or replace promptly.
5. Keep the fuel tank full to prevent condensation.
Always ll at the end of the day.
6. Inspect the hand spray wand nozzle (and spray bar
nozzles if equipped) to ensure they are free from
clogs and operating properly.
Every 50 Hours or Weekly Every 50 Hours or Weekly
Routine MaintenanceRoutine Maintenance
1. The FIRST 50 HOURS, change engine oil and oil
lter, then every 250 hours thereafter. (Page 5-11)
2. Lubricate the steering axle king pins and tie rods.
(Pages 5-6 to 5-8)
3. Check all battery connections and remove any
corrosion present. (Page 5-13)
4. Check air lter. Clean or replace if needed. (Page
5-12)
5. Perform previous routine maintenance and any
other engine preventive maintenance described in
the Engine Operator’s Manual.
Every 100 Hour or Monthly Every 100 Hour or Monthly
MaintenanceMaintenance
1. Check main engine belt. Replace if needed.
2. Change air lter. (Page 5-11)
3. Lubricate steering axle pivot. (Pages 5-6 to 5-8)
4. Perform previous routine maintenance and any
other engine preventive maintenance described in
the Engine Operator’s Manual.
7. Check the tires for proper ination before operating
the broom. (Pages 5-22 to 5-23)
8. Grease the brush core shaft bearings and brush lift
bushings. (Pages 5-6 to 5-8)
9. Check engine oil level. (Page 5-9)
10. Check hydraulic oil level and lters. (Page 5-18)
11. Check hydraulic uid at master cylinder in cab on
the oor. (Page 5-25)
12. Perform any other engine preventive maintenance
described in the Engine Operator’s Manual.