55
Maintenance
LB Performance CB95 Broom 5-3
MAINTENANCE SCHEDULE
Before performing any maintenance procedures on the
LB Performance CB95 Broom, review the safety infor-
mation in Section 1.
Always use the appropriate and
correct sized tools for the task at hand to prevent
damage or possible injury.
Always wear heat-resistant gloves
when handling hot components.
Following the maintenance schedules and procedures
will maintain the machine in top operating condition and
provide years of trouble-free operation. Refer to the
Engine Operator’s Manual accompanying your machine
for more detailed engine service information.
When performing any routine maintenance, always
include the previous routine maintenance hours in the
higher hourly schedule.
Changing oil and cleaning the machine
should only be done in a designated area where
the oil and chemicals can be contained. These by-
products should be discarded in accordance with
environmental regulations.
Table 5-1. Periodic Maintenance Schedule
SYSTEM ITEM
Every 10 Hours
Daily
Every 50 Hours
Weekly
Every 100 Hours
Monthly
Every 250 Hours
Quarterly
Every 500 Hours
Semi-Annually
Every 1000 Hours
Annually
Engine
Check oil level. X
Check coolant level. X
Replace coolant. X
Check primary and secondary air lters. X
Change air lters. X
Replace fuel lter. X
Check and drain fuel water separator. X
Change oil and oil lter. (Initial 50 Hours) X
Check main engine belt (Change every 3000
hours).
X
Hydraulic
Check hydraulic oil level and lters. X
Change hydraulic lters. X
Change hydraulic oil. X
Clean hydraulic oil strainer. X
Drain hydraulic tank. Replace suction
strainer.
X
Mechanical
Lubricate steering axle pivot. X
Lubricate steering axle king pins and tie rods. X
Replace drive axle oil. X
Repack wheel bearings. X
Check uid at master cylinder. X
Change lter for crankcase bleeding. X
To Next Page
Loading...
