Maintenance
LB Performance CB95 Broom5-16
Fuse Box Panel Fuse Box Panel
The electrical system is protected from overload
damage by fuses. If an electrical component fails to
operate, check the fuse panel rst to ensure that a fuse
has not “blown.” The panel is located on the right side
panel in the cab. See the following table for corre-
sponding fuse information. (Figure 5-12)
A blown fuse is an indication that there is an overload
that needs to be corrected. If you replace a fuse, but it
continues to blow, contact your authorized LB Perfor-
mance dealer.
Always replace a blown fuse with
the same rating as specied. Never replace with a
higher amperage rating. Damage to the electrical
system or re can occur from improper fuse
replacement.
Figure 5-12. Fuse Panel and Fuse Sizes
Dielectric GreaseDielectric Grease
Dielectric grease is a nonconductive, insulating com-
pound applied to electrical connectors. When applied
correctly, a high-quality dielectric grease displaces
debris and moisture in the connector. The proper appli-
cation of dielectric grease lls any gaps between pins
or in the connector which prevents debris and moisture
from creating corrosion of the electrical components.
Equipment damage can occur if using
low-quality, incompatible dielectric grease.
If not applied or incorrectly applied, corrosion can result
that causes rapid increase in resistance, intermittent
connections, overheating, and a variety of electrical
problems. Numerous electrical issues throughout the
machine can be avoided by the proper application and
use of dielectric grease.
Figure 5-13. Correct Application of Dielectric
Grease
To Next Page
Loading...
