CAUTION:
Neverremovethecoveronapowersupplyoranypartthathasthefollowinglabelattached.
Hazardousvoltage,current,andenergylevelsarepresentinsideanycomponentthathasthislabel
attached.Therearenoserviceablepartsinsidethesecomponents.Ifyoususpectaproblemwith
oneoftheseparts,contactaservicetechnician.
Readthesafetyinformationin“Safety”onpagevand“Installationguidelines”onpage35.
Attention:Staticelectricitythatisreleasedtointernalservercomponentswhentheserverispowered-on
mightcausetheservertohalt,whichmightresultinthelossofdata.Toavoidthispotentialproblem,
alwaysuseanelectrostatic-dischargewriststraporothergroundingsystemwhenyouworkinsidethe
serverwiththepoweron.
Toinstallahot-swappowersupply,completethefollowingsteps.
Note:Youmustinstallthefancageassemblybeforeremovingorinstallingthepowersupply.
Step1.Touchthestatic-protectivepackagethatcontainsthehot-swappowersupplytoanyunpainted
metalsurfaceontheserver;then,removethepowersupplyfromthepackageandplaceiton
astatic-protectivesurface.
Step2.Removethepower-supplyfillerpanelfromthepowerbay,ifoneisinstalled.
Chapter2.Installingoptionaldevices93
To Next Page
Loading...
