Lenovo System x3500 M4 - Removing a Memory Module

Operator information
panel assembly
Figure177.Operatorinformationpanelinstallation
Step8.Slidetheoperatorinformationpanelassemblyforwarduntilthereleaselatchclicksintoplace.
Step9.Connecttheoperatorinformationpanelassemblycabletothesystemboard(see“System-board
internalconnectors”onpage27
and“Internalcableroutingandconnectors”onpage312).
Step10.ReinstalltheDVDdrive(see“InstallingaDVDdrive”onpage206and“Installinganoptionaltape
drive”onpage209)whichyouremovedbeforeindrivebay1.
Step11.Connectthedrivecablestothebackofthedrivebay1.
Step12.Reinstallthefancageassembly(see“Installingthefancageassembly”onpage274).
Step13.Reinstalltheairbaffle(see“Installingtheairbaffle”onpage190).
Step14.Installandlocktheleft-sidecover(see“Installingtheleft-sidecover”onpage185).
Ifyouhavereplacedaservercomponentorinstalledanoptionaldeviceintheserver,youneedtoreconnect
thepowercordsandallexternalcables,andturnontheserverandperipheraldevices.
Removingamemorymodule
Usethisinformationtoremoveamemorymodule.
Readthesafetyinformationin“Safety”onpagevand“Installationguidelines”onpage35.
Ifyouarereplacingaservercomponentintheserver,youneedtoturnofftheserverandperipheraldevices,
anddisconnectthepowercordsandallexternalcables.
Toremoveadualinlinememorymodule(DIMM),completethefollowingsteps.
Step1.Carefullyturntheserveronitssidesothatitislyingflat,withthecoverfacingup.
Attention:Donotallowtheservertofallover.
Step2.Unlockandremovetheleft-sidecover(see“Removingtheleft-sidecover”onpage184).
Step3.Removetheairbaffleifinstalled(see“Removingtheairbaffle”onpage189).
Step4.LocatetheDIMMconnectorsonthesystemboard(see“System-boardinternalconnectors”on
page27).
Chapter6.Removingandreplacingcomponents261