Lenovo System x3500 M4 - Removing an Adapter

Step7.Installthe2.5-inchharddiskdrives(see“Installinga2.5-inchhot-swapharddiskdrive”onpage
200
).
Step8.Installthedrivebayfillerpanelsthatcomewiththeoptionintoemptydrivebays.
Step9.Connectthebackplaneconfigurationcable,powercable,signalcable,andtheconfigurationcable
(see“Internalcableroutingandconnectors”onpage312
).
Note:Youmayneedtoinstallthetwoscrewsonthebackplaneconfigurationcable.
Backplane
configuration
cable
Screws
Signal connector
(backplane configuration)
Figure127.Putscrewsonthebackplane
Step10.Installthebezel(see“Installingthebezel”onpage187).
Step11.Installtheleft-sidecover(see“Installingtheleft-sidecover”onpage185).
Step12.Reconnectthepowercordsandanycablesthatyouremoved.
Step13.Slidetheserverintotherack.
Ifyouhavereplacedaservercomponentorinstalledanoptionaldeviceintheserver,youneedtoreconnect
thepowercordsandallexternalcables,andturnontheserverandperipheraldevices.
Removinganadapter
Usethisinformationtoremoveanadapter.
Readthesafetyinformationin“Safety”onpagevand“Installationguidelines”onpage35.
Ifyouarereplacingaservercomponentintheserver,youneedtoturnofftheserverandperipheraldevices,
anddisconnectthepowercordsandallexternalcables.
Toremoveanadapter,completethefollowingsteps.
Step1.Carefullyturntheserveronitssidesothatitislyingflat,withthecoverfacingup.
Attention:Donotallowtheservertofallover.
Step2.Unlockandremovetheleft-sidecover(see“Removingtheleft-sidecover”onpage184).
Chapter6.Removingandreplacingcomponents213