Lenze L-force 8400 BaseLine D - Page 177

Firmware 03.00 - DMS EN 5.0 - 07/2009 L 177
8400 BaseLine D | Software Manual
Parameter reference
Parameter list | C00007
C00007
C00010
Parameter | Name:
C00007 | Select control mode
Data type: UNSIGNED_16
Index: 24568
d
= 5FF8
h
Configuration of the digital inputs
Selection list (Lenze setting printed in bold) Info
0 Wiring has changed This display appears if the defined configuration has
been reparameterised via the connection parameters.
10 Terminal 0 The technology application is controlled using the digital
input terminals of the controller.
• DI1 = JOG 1/3
• DI2 = JOG 2/3
•DI3 = DCB
•DI4 = R/L
12 Terminal 2 The technology application is controlled using the digital
input terminals of the controller.
• DI1 = JOG 1/3
• DI2 = JOG 2/3
•DI3 = QSP
•DI4 = R/L
14 Terminal 11 The technology application is controlled using the digital
input terminals of the controller.
•DI1 = R/L
•DI2 = DCB
•DI3 = MPotUp
•DI4 = MPotDown
16 Terminal 16 The technology application is controlled using the digital
input terminals of the controller.
• DI1 = JOG 1/3
• DI2 = JOG 2/3
•DI3 = R/QSP
•DI4 = L/QSP
20 Keypad The technology application is controlled via the keypad:
 C00728
: Setpoint selections
 C00002
: Device commands
 C00003
: Status of last device command
 Increase speed
 Reduce speed
21 PC The technology application is controlled using the "Free
parameters" of the controller (PC control).
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00010 | Minimum analog setpoint
Data type: INTEGER_16
Index: 24565
d
= 5FF5
h
From version 03.00.00
Setting range (min. value | unit | max. value)
0.0 % 100.0
Subcodes Lenze setting Info
C00010/1 0.0 % Min. analog setpoint
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100