3-14 Service Manual
7013-XXX
Enable Edge to Edge Copy
This setting is set to either on or off. Off is the default setting.
Reset Fuser Count
Resets the fuser count value to zero. The Event Log records each time that a user executes the Reset Fuser
Count operation. See “Event Log” on page 3-27 for more information. This setting appears only if the
Maintenance Warning and Intervention function is enabled in the printer Configuration ID.
To reset the fuser count:
1. Select Printer Setup from Diag Menu, and press Select ( ).
2. Select Reset Fuser Cnt, and press Select ( ).
3. Select Reset, and press Select ( ).
Resetting Fuser Count Value appears.
To cancel a reset, press Back ().
EP Setup
EP Setup displays the following selections:
• EP Defaults
• Fuser Temperature (Fuser Temp)
• Transfer
• Print Contrast
• Gap Adjust
• Automatic Darkness Adjustment (Auto Dark Adj)
EP Defaults
Restores all EP settings to factory default values. Selections are Restore and Do Not Restore.
Fuser Temperature (Fuser Temp)
Changing this setting can reduce media curl or melting of some letterhead images. Selections are Normal
(default), Lower, and Lowest.
Transfer
The transfer can be adjusted to Low, Medium, or High. The default setting is Medium.
Print Contrast
The print contrast can be adjusted to Low, Medium, or High. The default setting is Medium.
Charge Roll
The charge roll can be adjusted to Low, Medium, or High. The default setting is Medium.
Gap Adjust
Adjusts the minimum gap between sheets during printing. This setting reduces speed (pages per minute), but
can be used to reduce curl of printed media and improve stacking in the output bin.
The range is 0 (default) to 255. Adjusting by one results in 9 mm of increased gap.
To Next Page
Loading...
Need help?
General
