3-32 Service Manual
7013-XXX
Font Sharpening
This setting is used to set a text point size value below which the hig- frequency screens will be used when
printing data. This setting affects only PCL, PostScript and PDF emulators.
Settings are in the range of 0–150 (24 is the default). For example, if the value is set to 24, then all fonts sized 24
points or less use the high-frequency screens.
To adjust the Font Sharpening setting, perform the following steps:
1. In the configuration menu, scroll to the Font Sharpening menu item, and press .
2. Use the or to increase or decrease the setting’s value. Pressing decreases the value, and
pressing increases the value.
3. Press to accept the setting.
Reduced Curl
This setting only applies to devices with an instant on fuser. The settings are On and Off. Off is the default
setting. When set to On, throughput is reduced. The On setting can be used on paper only.
USB Speed
The USB Speed setting is used to set the throughput of the USB port on the MFP. The settings are Auto, which
is the default, and Full. Full forces the USB port to tun at full speed.
Exit Config Menu
With the Exit Config menu item displayed, press Select ( ) to exit the Configuration Menu. The printer
performs a power-on reset and returns to normal mode.
To Next Page
Loading...
Need help?
General
