Use To
Image Smoothing
On
O
Enhance the contrast and sharpness of low‑resolution images and
smoothen their color transitions.
Notes:
• O is the factory default setting.
• Image Smoothing has no eect on images that are 300 dpi or higher
in resolution.
PCL Emul menu
Use To
Font Source
Resident
Download
All
Specify the set of fonts used in the Font Name menu.
Notes:
• “Resident” is the factory default setting. It shows the factory default
set of fonts downloaded in the RAM.
• “Download” shows all the fonts downloaded in the RAM.
• “All” shows all fonts available to any option.
Font Name
Courier 10
Identify a specific font and where it is stored.
Note: Courier 10 is the factory default setting.
Symbol Set
10U PC‑8
12U PC‑850
Specify the symbol set for each font name.
Notes:
• 10U PC‑8 is the U.S. factory default setting. 12U PC‑850 is the
international factory default setting.
• A symbol set is a set of alphabetical and numeric characters,
punctuation, and special symbols. Symbol sets support the dierent
languages or
specific
programs, such as math symbols for
scientific
text. Only the supported symbol sets are shown.
PCL Emulation Settings
Point Size
1.00–1008.00
Change the point size for scalable typographic fonts.
Notes:
• 12 is the factory default setting.
• Point size refers to the height of the characters in the font. One point
equals approximately 0.014 of an inch. This can be increased or
decreased in 0.25‑point increments.
PCL Emulation Settings
Pitch
0.08–100.00
Specify the font pitch for scalable monospaced fonts.
Notes:
• 10 is the factory default setting.
• Pitch refers to the number of fixed‑space characters per inch (cpi).
This can be increased or decreased in 0.01‑cpi increments.
• For non‑scalable monospaced fonts, the pitch appears on the
display but cannot be changed.
Understanding the printer menus 117
To Next Page
Loading...
Need help?
General
