Tray linking does not work
Notes:
• The trays can detect paper length.
• The multipurpose feeder does not automatically detect the paper size. You must set the size from the
Paper Size/Type menu.
Action Yes No
Step 1
a Open the trays, and then check if they contain paper of the
same size and type.
• Check if the paper guides are in the correct positions for
the size of the paper loaded in each tray.
• Check if the paper size indicators on the paper guides are
aligned with the paper size indicators on the tray.
b Resend the print job.
Do the trays link correctly?
The problem is
solved.
Go to step 2.
Step 2
a From the printer control panel, set the paper size and type in
the Paper menu to match the paper loaded in the trays to be
linked.
Note: The paper size and type must match for trays to be
linked.
b Resend the print job.
Do the trays link correctly?
The problem is
solved.
Contact
customer
support.
Unexpected page breaks occur
Action Yes No
Step 1
Adjust the print timeout settings.
a From the printer control panel, navigate to:
Settings > General Settings > Timeouts > Print Timeout
b Select a higher setting and then, depending on your printer
model, select
or Submit.
c Resend the print job.
Did the file print correctly?
The problem is
solved.
Go to step 2.
Step 2
a Check the original file for manual page breaks.
b Resend the print job.
Did the file print correctly?
The problem is
solved.
Contact
customer
support.
Troubleshooting 192
To Next Page
Loading...
