Action Yes No
Step 2
a From the Quality menu on the printer control panel, increase
the toner darkness.
Note: 4 is the factory default setting.
b Resend the print job.
Is the print still too light?
Go to step 3. The problem is
solved.
Step 3
From the printer control panel, set the paper type, texture, and
weight in the Paper menu to match the paper loaded in the tray.
Is the tray set to the type, texture, and weight of the paper loaded?
Go to step 4. Specify the paper
type, texture, and
weight from the tray
settings to match the
paper loaded in the
tray.
Step 4
a Depending on your operating system, specify the paper type,
texture, and weight from Printing Preferences or from the Print
dialog.
b Resend the print job.
Is the print still too light?
Go to step 5. The problem is
solved.
Step 5
Make sure that the paper has no texture or rough finishes.
Are you printing on textured or rough paper?
From the printer
control panel, set the
paper texture in the
Paper menu to match
the paper loaded in
the tray
Go to step 5.
Step 6
a Load paper from a fresh package.
Note: Paper absorbs moisture due to high humidity. Store
paper in its original wrapper until you use it.
b Resend the print job.
Is the print still too light?
Go to step 7. The problem is
solved.
Step 7
Replace the imaging kit, and then resend the print job.
Is the print still too light?
Contact
customer
support.
The problem is
solved.
Troubleshooting 201
To Next Page
Loading...
Need help?
General
