2-120 Service Manual
4062
983.00 Communication
failure
Invalid command received by
the paper port device.
Replace the system card
assembly.
Go to “System card
assembly removal (T650,
T652, T654, T656)” on
page 4-76.
984.00 Communication
failure
Invalid command parameter
received by the paper port
device.
Replace the system card
assembly.
Go to “System card
assembly removal (T650,
T652, T654, T656)” on
page 4-76.
985.01 Service engine RFID
communications
Generic hardware error 1. Check the RFID firmware
card, RFID interface card,
RFID cable, and RFID
option for correct
installation. Go to “High
capacity input tray (HCIT)
pick arm bracket
assembly removal” on
page 4-130.
2. Replace the RFID UHF
option.
Note: There can be no other
connectivity options installed
on printers that have the RFID
UHF option installed. If any
connectivity option is installed
(other than the RFID interface
card), a 985.xx error will occur
985.02 Service engine RFID
communications
Printer having problems
communicating with radio
1. Check the RFID firmware
card, RFID interface card,
RFID cable, and RFID
option for correct
installation. Go to “High
capacity input tray (HCIT)
pick arm bracket
assembly removal” on
page 4-130.
2. Replace the RFID UHF
option.
Note: There can be no other
connectivity options installed
on printers that have the RFID
UHF option installed. If any
connectivity option is installed
(other than the RFID interface
card), a 985.xx error will occur
Error
code or
message
Error contents Description/Action Possible repair actions
To Next Page
Loading...
