Lexmark T650n - Page 115

Diagnostic information 2-83
4062
920.06 Fuser warm-up failure
Fuser type = 1
The fuser hot roll temperature
does not increase while the
lamp is turned on.
1. Turn the machine off/on
and ensure the fuser unit
assembly is properly
installed.
2. Ensure the proper voltage
fuser is installed in the
machine.
3. Check all connections on
the fuser and LVPS card
assembly.
4. Ensure the proper voltage
setting is being used on the
switchable LVPS assembly.
5. Replace the fuser unit
assembly if problem
remains. Go to “Fuser unit
assembly removal (T650,
T652, T654)” on
page 4-16.
6. Replace the LVPS card
assembly if problem
remains. Go to “LVPS card
assembly removal
(T650)” on page 4-64 or
“LVPS card assembly
removal (T652, T654)” on
page 4-66.
920.07 Fuser warm-up failure
Fuser type = 1
The fuser hot roll temperature
is not maintained properly
while the media in the fuser
nip.
1. Turn the machine off/on
and ensure the fuser unit
assembly is properly
installed.
2. Ensure the proper voltage
fuser is installed in the
machine.
3. Check all connections on
the fuser and LVPS card
assembly.
4. Replace the fuser unit
assembly if problem
remains. Go to “Fuser unit
assembly removal (T650,
T652, T654)” on
page 4-16.
5. Replace the LVPS card
assembly if problem
remains. Go to “LVPS card
assembly removal
(T650)” on page 4-64 or
“LVPS card assembly
removal (T652, T654)” on
page 4-66.
Error
code or
message
Error contents Description/Action Possible repair actions