Diagnostic aids 3-13
4062-XXX
Press Back to return to OUTPUT BIN TESTS.
Feed To All Bins
This test can be used to verify that the printer can feed media to the standard bin or any installed output
options. No information will be printed on the test pages, as the printhead is not engaged during the feed test.
The media feeds from the default paper source.
To run the Feed To All Bins Test:
Select Feed To All Bins from OUTPUT BIN TESTS.
The printer feeds a separate piece of media to the standard bin first, then it feeds a separate piece of media to
each output bin installed in the following order:
The test is continuous until Stop is pressed.
Press Back to return to OUTPUT BIN TESTS.
Sensor Test (standard output bin)
This test is used to verify if the standard bin sensor is working correctly.
To run the Sensor Test for the standard bin:
1. Select Sensor Test from OUTPUT BIN TESTS.
2. Select Standard Bin from Sensor Tests.
3. Standard Bin Testing displays briefly, and then Bin Empty empty displays.
4. Select NearFull or Full sensor to test.
The following screen is displayed:
Standard Bin x
Full=Open NearFull=Open
Bin Empty empty
• Full–Bin full sensor
• NearFull–Bin near full sensor
5. Manually actuate the bin sensor by moving the flag in and out of the sensor. The display indicates Open
when the flag is out of the sensor and Closed when the flag is in the sensor.
6. Press Back or Stop to exit the test.
Sensor Test (Output Expander)
Order sheets
are fed
Output bins
Order sheets
are fed
Output bins
Order sheets
are fed
Output bins
1 Standard bin 9 Bin #8 17 Bin #5
2 Bin #1 10 Bin #9, 18 Bin #4
3 Bin #2 11 Bin #10 19 Bin #3
4 Bin #3 12 Bin #10 20 Bin #2
5 Bin #4 13 Bin #9 21 Bin #1
6B
in #5 14 Bin #8 22 Standard bin
7 Bin #6 15 Bin #7
8 Bin #7 16 Bin #6
To Next Page
Loading...
