3-16 Service Manual
4062-XXX
BASE SENSOR TEST
This test is used to determine if the sensors located inside the printer are working correctly.
To run the Base Sensor Test:
1. Select BASE SENSOR TEST from the DIAGNOSTICS menu.
The following sensors are listed:
• Toner Level–Toner level sensor (remove the cartridge and replace to actuate the sensor)
• Input–Input sensor
• Output–Output (exit) sensor
• NarrowMedia–Output (exit) sensor
• Front Door–Front door sensor
2. Manually actuate the sensors to verify that each sensor switches from Open to Closed.
3. Press Back or Stop to exit the test.
PRINTER SETUP
Defaults
US/Non-US defaults changes whether the printer uses the US factory defaults or the non-US factory defaults.
The settings affected include paper size, envelope size, PCL symbol set, code pages, and units of measure.
WARNING: Changing this setting resets the printer to factory defaults, and data may be lost. It cannot be
undone.
Printed Page Count
The page count can only be viewed and cannot be changed.
To view the page count:
1. Select Page Count from PRINTER SETUP.
2. Press Back to return to PRINTER SETUP.
Perm Page Count (permanent page count)
The permanent page count can only be viewed and cannot be changed.
To view the permanent page count:
1. Select Perm Page Count from PRINTER SETUP.
2. Press Back to return to PRINTER SETUP.
Serial Number
The serial number can only be viewed and cannot be changed.
To view the serial number:
1. Select Serial number from PRINTER SETUP.
2. Press Back to return to PRINTER SETUP.
To Next Page
Loading...
