Repair information 4-109
4062-XXX
Anti-tip latch assembly removal
The left and right anti-tip latch assemblies are the same, and only one is in a package. The instructions below
are for removing the left latch, but removing the right latch is similar.
1. Remove the 550-sheet media tray assembly. Go to “550-sheet option tray assemblyl” on page 4-105.
2. Turn the drawer upside down, and unsnap the two hooks (A) securing the anti-tip latch assembly to the
drawer with a flathead screwdriver.
Note: The hooks might break when detaching the anti-tip latch assembly from the drawer.
3. Remove the anti-tip latch assembly.
550-sheet frame assembly removal
Note: The 550-sheet frame assembly is not a FRU.
1. Remove the 550-sheet pick arm bracket assembly. Go to “550-sheet pick arm bracket assembly
removal” on page 4-107.
2. Release the hooks securing the sensor (pass through) to the drawer.
3. Remove the sensor (pass through) from the drawer.
To Next Page
Loading...
