Lexmark T650n - Sensor (Pass Through) with Cable Removal

Repair information 4-101
4062-XXX
5. Remove the 250-sheet frame assembly.
Sensor (pass through) with cable removal
1. Remove the 250-sheet frame assembly. Go to “250-sheet frame assembly removal” on page 4-100.
2. Disconnect the sensor (pass through) cable connector from the 250-sheet controller card.
3. Remove the sensor (pass through) with cable.
250-sheet controller card assembly removal
1. Remove the 250-sheet frame assembly. Go to “250-sheet frame assembly removal” on page 4-100.