Repair information 4-99
4062-XXX
250-sheet media out actuator removal
Note: Carefully remove the base machine from the input option tray assembly before proceeding.
1. Remove the 250-sheet pick arm bracket assembly. Go to “250-sheet pick arm bracket assembly
removal” on page 4-97.
2. Release the hook (A) securing the 250-sheet media out actuator to the 250-sheet pick arm bracket
assembly.
3. Remove the 250-sheet media out actuator from the drawer.
Anti-tip latch assembly removal
Note: Carefully remove the base machine from the input option tray assembly before proceeding.
The left and right anti-tip latch assemblies are the same, and only one is in a package. The instructions below
are for removing the left latch, but removing the right latch is similar.
1. Remove the 250-sheet media tray assembly. Go to “250-sheet option tray assembly” on page 4-96.
2. Turn the drawer upside down, and unsnap the two hooks (A) securing the anti-tip latch assembly to the
drawer with a flathead screwdriver.
Note: The hooks might break when detaching the anti-tip assembly from the drawer.
To Next Page
Loading...
