2-28 Service Manual
4062
203.01 Internal duplex drive
motor control failure.
Internal duplex
The internal duplex drive motor
motor does not reach the
proper operating speed at the
specified time.
1. Remove all media present
in media path.
2. Check all connections on
the duplex media entrance
drive motor assembly.
3. Check all connections on
the system card assembly.
4. Replace the duplex media
entrance drive motor
assembly if problem
remains. Go to “Duplex
drive motor assembly
removal (T652, T654)” on
page 4-10.
203.08 Redrive motor load
error
The redrive motor assembly
has failed or caused high
mechanical load during the
warm up sequence.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to “Redrive
motor assembly removal
(T652, T654)” on
page 4-55.
203.10 Redrive motor control
failure.
Media tray 1
The redrive motor does not
reach the proper operating
speed at the specified time.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to “Redrive
motor assembly removal
(T652, T654)” on
page 4-55.
203.18 Redrive motor
assembly underspeed
error.
The redrive motor assembly
does not rotate at the specified
speed.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to “Redrive
motor assembly removal
(T652, T654)” on
page 4-55.
Error
code or
message
Error contents Description/Action Possible repair actions
To Next Page
Loading...
