Menu item Description
Allow Custom Job Scans
On
Off
Lets you scan multiple documents into one file
Note: On is the factory default setting. If On is selected, the
Allow Custom Job Scans setting can be enabled for specific
jobs.
Scanner Jam Recovery
Job level
Page level
Specifies how a scan job should be reloaded if a paper jam
occurs in the ADF
Notes:
• If “Job level” is selected, then the entire scan job must be
scanned again if a paper jam occurs.
• If “Page level” is selected, then only the jammed page
forward must be scanned again.
Web Page Refresh Rate
30–300
Specifies the number of seconds between Embedded Web
Server refreshes
Note: 120 seconds is the factory default setting.
Contact Name Specifies a contact name for the printer
Note: The contact name will be stored on the Embedded Web
Server.
Location Specifies the location of the printer
Note: The location will be stored on the Embedded Web
Server.
Alarms
Alarm Control
Cartridge Alarm
Sets an alarm to sound when the printer requires operator
intervention
Available selections for each alarm type are:
Off
Single
Continuous
Notes:
• Single is the factory default setting for Alarm Control.
Single sounds three quick beeps.
• Off is the factory default setting for Cartridge Alarm. Off
means no alarm will sound.
• Continuous repeats three beeps every 10 seconds.
Timeouts
Standby Mode
1–240
Disabled
Specifies the number of minutes of inactivity before the system
enters a lower power state
Note: 15 minutes is the factory default setting.
Understanding printer menus
156
To Next Page
Loading...
Need help?
General
