– Have bent corners
– Have rough, cockle, or laid finishes
• Adjust the width guides to fit the width of the envelopes.
Note: A combination of high humidity (over 60%) and the high printing temperature may wrinkle or seal envelopes.
Tips on using letterhead
Page orientation is important when printing on letterhead. Use the following table to determine which direction to
load the letterhead:
Source or process Print side and paper orientation
• Standard 250-sheet tray
• Optional 550-sheet tray
• Simplex (one-sided) printing
from trays
Printed letterhead design is placed faceup. The top edge of the sheet with the logo is
placed at the front of the tray.
AB
C
Duplex (two-sided) printing from
trays
Printed letterhead design is placed facedown. The top edge of the sheet with the logo
is placed at the back of the tray.
AB
C
Note: Check with the manufacturer or vendor to determine whether the chosen preprinted letterhead is acceptable for
laser printers.
Printing
69
To Next Page
Loading...
