Installing an optional tray or drawer
The printer supports two additional input sources: an optional 550-sheet tray and a 650-sheet duo drawer (Tray 2) with
an integrated multipurpose feeder.
Note: Some printer models may not support the optional 550-sheet tray.
CAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two or more trained
personnel to lift it safely.
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the wall
outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and
unplug any cables going into the printer.
1 Unpack the optional tray, and then remove all packing material and the dust cover.
2 Place the tray near the printer.
Note: If you are installing both the optional tray and the 650-sheet duo drawer, then the optional 550-sheet tray
must always be installed as the first tray (configuring from the bottom up).
3 Align the 650-sheet duo drawer with the optional 550-sheet tray, and then lower it into place.
Additional printer setup
39
To Next Page
Loading...
Need help?
General
