Fax Settings menu
Fax Mode (Analog Fax Setup) menu
Analog Fax Setup mode sends the fax job by way of a telephone line.
General Fax Settings
Menu item Description
Fax Name or Station Name Specifies the name of the fax in the printer
Fax Number or Station Number Specifies the number assigned to the fax
Station ID
Fax Name or Station Name
Fax Number or Station Number
Specifies how the fax is identified
Enable Manual Fax
Off
On
Sets the printer to fax manually only, which requires a line splitter and a telephone
handset
Notes:
• Use a regular telephone to answer an incoming fax job and to dial a fax number.
• Touch # 0 on the numeric keypad to go directly to the Manual Fax function.
Memory Use
Equal
Mostly sent
All send
All receive
Mostly receive
Defines the allocation of non-volatile memory between sending and receiving fax jobs
Notes:
• Equal is the factory default setting. Equal splits the memory for sending and
receiving fax jobs into equal amounts.
• Mostly sent specifies that most of the memory is set to send fax jobs.
• All send specifies that all the memory is set to send fax jobs.
• All receive specifies that all the memory is set to receive fax jobs.
• Mostly receive specifies that most of the memory is set to receive fax jobs.
Cancel Faxes
Allow
Don't Allow
Specifies whether or not the printer cancels fax jobs
Caller ID
On
Off
Alternate
Specifies the type of caller ID being used
Fax number masking
Off
From left
From right
Specifies the direction from where digits are masked in an outgoing fax number
Note: The number of characters masked is determined by the “Digits to mask” setting.
Digits to mask
0–58
Specifies the number of digits to mask in an outgoing fax number
Understanding printer menus
194
To Next Page
Loading...
Need help?
General
