Page 10 / 89 Section 2. Controls and connections
2. Controls and connections
2.1. Front panel view
Figure 2-1. Front panel view
Control Lock Disables or enables front panel operation. When red illuminated, all
operations on front panel are prohibited. See section 4.2.1 on page
16 for more information.
Output Lock Locks and protects one (or more) outputs. Inhibits accidental input
changing on protected output. See section 4.2.8 on page 20 for more
information.
Source buttons Source buttons have three functions: to select an input, to select a
preset and to view the selected input’s state (only in TAKE mode).
See section 4.2 on page 16 for more information.
Destination buttons Destination buttons have two functions: to select an output and to view
the selected output’s state. See section 4.2 on page 16 for more
information.
Take / Auto Displays the actual switching mode of the router (TAKE or
AUTOTAKE). Long press toggles the switching mode, short press
executes switching in TAKE mode. See section 4.2.2 on page 16 for
more information.
Load Preset Loads and executes a previously saved preset from one of the preset
memories.
Save Preset Stores actual matrix state in one of the preset memories. See section
4.2.7 on page 19 for more information.
Power switch The matrix can be switched ON/OFF with the switch.
Info: MX12x12DVI-Plus front panel differs only in that it has 12 source and 12 destination
buttons.
Info: MX9x9DVI-Plus front panel differs only in that it has 9 source and 9 destination buttons.
To Next Page
Loading...
Need help?
General
