Standalone MX DVI-Plus family
User’s Manual
Section 4. Operation Page 17 / 89
View current state in TAKE mode
If all source and destination buttons and TAKE button are unlit (the unit is in TAKE mode,
and no input was selected in last 3 seconds), user can verify both input and output
connections. This informative display will remain for 3 seconds, and then all button lamps
go out. In TAKE mode no accidental change can be done unless TAKE button is pressed.
For viewing input connections, press and release a source button. Now the selected
source button and all destination buttons will light up which are currently connected to the
selected source.
For viewing output connections, press and release a destination button. Now the source
button which is connected to the selected destination will light up. If no source button is
lighting, the selected destination is in muted state.
View current state in AUTOTAKE mode
In AUTOTAKE mode only states of destinations can be viewed.
Press and release the required destination button. Now the source button which is
connected to the selected destination will light up. If no source button is lighting, the
selected destination is in muted state. By pressing another destination button, the state of
that destination can be seen.
Info: Be careful, as in AUTOTAKE mode if a source button is pressed, it is immediately
connected to the last selected destination.
4.2.5. Switching
Creating a connection or multiple connections in TAKE mode
Step 1. First press and release the selected source button. The pressed source button and
all destination buttons which are currently connected to this source will light up. The
dark remaining destination buttons are not connected to this source. This is an
informative display about current status of the selected input (view only).
Step 2. Press and release the selected destination button or buttons which has to be
connected to the selected source. The preselected destination button(s) start(s)
blinking.
Step 3. Press and release TAKE button to execute the tie or ties. Now the selected input is
switched to the selected output or to the multiple outputs.
Info: If the pressed destination is locked then it could not be selected. This is indicated by a short
flash of the OUTPUT LOCK when a locked destination is pressed.
Disconnecting or muting in TAKE mode
Step 1. First press and release the selected source button. The pressed source button and
all destination buttons which are currently connected to this source will light up. The
dark remaining destination buttons are not connected to this source. This is an
informative display about current status of the selected input (view only).
Step 2. Press and release the selected, green lighting destination button which has to be
disconnected from the selected source. The pressed destination or multiple
destinations will turn dark.
Step 3. Press and release TAKE button to execute disconnection.
Info: Deselected destinations are disconnected from any source, thus output devices will display
black image or "no signal" message, or automatically will turn off.
Info: If the pressed destination is locked then it could not be deselected. This is indicated by a
short flash of the OUTPUT LOCK when a locked destination is pressed.
Info: Multiple switching and deselecting actions can be done simultaneously, during only one
TAKE action.
To Next Page
Loading...
Need help?
General
