Lightware MX16x16DVI-Plus - 8.4.24. Reload Factory Default IP Settings; 8.4.25. Load DHCP IP Settings (only IP address!)

Page 60 / 89 Section 8. Programmers reference
8.4.24. Reload factory default IP settings
Description: After issuing this command over serial connection the router will reload the
factory default IP setup.
Format
Example
Command
{IP_CONFIG=!}
→
{ip_config=!}
Response
(Changing●IP●
configuration…)CrLf
←
(Changing IP
configuration…)CrLf
(DONE!)CrLf or
(FAILED!)CrLf
←
(DONE!)CrLf or (FAILED!)CrLf
Parameters after successful command execution:
Parameter
Value
IP address
192.168.254.254
port number
10001
Subnet mask
255.255.0.0
Gateway
0.0.0.0
Info: IP settings can NOT be changed with this protocol command via Ethernet connection, only
via serial port. To change the IP settings via Ethernet, use the Lightware Device Controller
software (section 5.9.1 on page 38) or the built-in website (section 6.4). Default settings
can be reloaded by the front panel buttons as well (section 4.3.5).
8.4.25. Load DHCP IP settings (only IP address!)
Description: After issuing this command over serial connection the router will inquire IP
address with DHCP.
Format
Example
Command
{IP_CONFIG=D}
→
{ip_config=D}
Response
(Changing●IP●
configuration…)CrLf
←
(Changing IP
configuration…)CrLf
(DONE!)CrLf or
(FAILED!)CrLf
←
(DONE!)CrLf or (FAILED!)CrLf
Parameters after successful command execution:
Parameter
Value
IP address
Acquired with DHCP
port number
unchanged
Subnet mask
unchanged
Gateway
unchanged
Info: IP settings can NOT be changed with this protocol command via Ethernet connection, only
via serial port. To change the IP settings via Ethernet, use the Lightware Device Controller
software (section 5.9.1 on page 38 or the built-in website (section 6.4 on page 48). Default
setting can be reloaded by the front panel buttons as well (section 4.3.5 on page 22).
8.4.26. View LAN versions
Description: Shows information about the LAN interface.
Format
Example
Command
{LAN_VER=?}
→
{lan_ver=?}
Response
(MAC_ADDR=<mac>)CrLf
(WEB_VER=<ver1>)CrLf
(SERVER_VER=<ver2>)CrLf
←
←
←
(MAC_ADDR=00-20-4A-E3-1D-E42)CrLf
(WEB_VER=1.4.0)CrLf
(SERVER_VER=1.1.5)CrLf