Press the [F5] [ENT] to view the TARGET POINT
screen. Reference point is changed.
Input the new PH and repeat the same procedure as
the above.
3.2 REM
3.2.1 General Pictures of Measurement
With REM measurement, a prism (Reference point) is set approximately directly below the
place to be measured, and by measuring the prism, the height to the target object can be
measured. This makes it easy to determine the heights of electric power lines, bridge
suspension cables, and other large items used in construction.
From the LinertecExpress screen, Select [F2] [REM]
and press [ENT] to view MEASURE screen.
Please press [ENT] after measuring distance.
17
To Next Page
Loading...
