Linertec LTS-200 Series - Point Code List; Point Code

Your desired points are deleted and found as described above.
After selecting desired point with arrow key, press [ENT] to view the POLAR. DATA EDIT
screen to edit.
10.3 Point Code List
Select 3. POINT CODE LIST and press [ENT] to
view the POINT CODE LIST screen.
10.3.1 Point Code
The PC, Point Code can be used for adding your desired attributes to Rect. and
Polar data. If Point Codes are stored under the job named "PointCodeList", you can easily
select one of the Point Codes from the list or edit one of them after pressing [ENT].
Please note, that Point Codes, which are saved in another job can not be referred to as a list.
PointCodeList：
Making “PointCodeList”:
PointCodeList can be created by using function of “5.4.1 Point Code List”
Use this function to create, edit and add PointCodeList.
Importing “PointCodeList” file:
PointCodeList can be used after importing it from external devices.
After importing, it is stored in the internal memory of the instrument. To store user defined
”PointCodeList”, please carry out following procedure.
Preparing “PointCodeList” file:
Make a “PointCodeList.csv” file with reference to a sample “PointCodeList.csv” file that is
contained in the “LTS-200 Supplement Disk” for the format.
113