Linertec LTS-200 Series User Manual

Select 2. 2D SURFACE and press [ENT] to view
POINT SELECTION FROM THE LIST screen.
If you press [F5] [PAGE], you can see another
screen.
You select the order of points, which define the polygon at this screen.
How to select points of polygon
[ENT] Key：
Move to point selection by [F3] and [F4] arrow keys
and press [ENT] to select them one by one, each
indication is reversed as follows.
Reverse display shows that it was selected.
If you cancel the selection of the point, press [ENT]
again.
You can cancel the selected points one by one
after pressing [ALL].
[F2][ALL] Key
Press [F2] [ALL] to select all stored points of current JOB. The order of points is according
to the arrangement of the memory.
If you press [F2] [ALL] again, the selection of all points is canceled.You can cancel the
selected points by [ENT] one by one, after pressing [ALL].
If you press [F2] [ALL] after you already selected some points, the selection of all points
is reversed.
[F3] [FROM] key and [F4] [TO] key
You can define the range of polygonal points from all points of current JOB by [F3] [FROM]
and [F4] [TO] as follows.
81

Linertec LTS-200 Series Specifications

General

Brand	Linertec
Model	LTS-200 Series
Category	Measuring Instruments
Language	English