Start-up
- 50 - 10.13
13.7 Mode Manual
Manual welding mode allows welding inde-
pendant of characteristic lines.
 Press key menu 48.
 Select menu option „characteristics“ by
turning operation knob 52.
 Conrm menu option „characteristics“ by
pressing operation knob 52.
 Select menu option „manual“ by turning
operation knowb 52.
 Conrm manue option „manual“ by press-
ing operation knob 52.
 Press key 46, 50 or 51 to exit menu and
return to standard display.
Abb. 22: Manual mode
13.8 Secondary parameters
 Press key secondary parameter 46 or 51
to open the secondaryparamenter menu.
 Select the required secondary parameter
by turning operation knob 52.
 Conrm set secondary parameter by
pressing operation knob 52.
 Set parameter value 72 as required by
turning operation knob 52.
70 7271
Abb. 23: Secondary parameters
70 Symbol secondary parameter
71 Factory setting
72 Parameter value
 Conrm parameter value 72 by pressing
operation knob 52.
 Press key 46, 50 or 51 to exit menu and
return to standard display.
To Next Page
Loading...
Need help?
General
