LORCH M-Pro Performance Series - Special Functions

Start-up
- 54 - 10.13
Delete job
 Press key Tiptronic 50.
 Select menu option „delete job” by turning
operation knob 52.
 Conrm menu option „delete job” by press-
ing operation knob 52.
 Select the job to be deleted by turning op-
eration knob 52.
 Conrm this job by pressing operation
knob 52.
9 Safety question „delete job?” appears.
 Select „YES“ to delete this job by turning
operation knob 52.
Abb. 33: delete job
 Conrm „YES“ by pressing operation knob
52.
 Press key 46, 50 or 51 to exit menu and
return to standard display.
13.10 Special functions
Gas test
 Turn the unit OFF using main switch 9.
 Press the torch key and keep it pressed.
 Turn the unit ON using main switch 9.
9 The solenoid valve of the unit will go on
and the gas supply can be tested/adjust-
ed. The function is active for 30 seconds
and will be automatically stopped. Re-
pressing the torch key. can interrupt the
gas test.
Fan test
 Turn the unit ON using main switch 9.
9 The fan will start for function purposes.
Operation panel test
 Press the mode key 47 for at least 2 sec-
onds.
9 The complete display panel of the graphic
display will ash.
 Press the key operation mode 47 again.
9 Another display test follows.
 Press the key operation mode 47 again.
9 The operation panel test will be initiated.
 Press and turn the keys as shown in the
graphic display.
 If there is no input for 20 seconds, the op-
eration panel test will be cancelled auto-
matically.