LORCH M-Pro Performance Series User Manual

Menu structure
- 57 -10.13
Main menu Level 1 Level 2 Note
Sprache/
language
Deutsch Select menu language.
English
...
Characteristics Manual All settings can be performed independ-
antly from a characteristic line.
SG2/3 0,8mm 82/18 Depending on type of model are various
characteristics set in the manu (material-
gas-wire combination).
...
Display Mode Current and Voltage Different display settings can be se-
lected.
Welding voltage
Welding current
Tiptronic see chapter „Tiptronic” page 51
Options Characterist. type EU Display in accordance to EU (european)
classication.
AWS Display in accordance to AWS (American
Weld¬ing Society) classication.
Interval-Welding On Off To switch interval welding on/off.
Spot Welding On Off To switch spot welding on/off.
Factory Settings ... reset?
No Yes
Master reset to reset all settings back to
factory settings.
Delete All Jobs?
No Yes
To delete all jobs.
Diagnosis Firmware Version Displays Firmware Version.
Serial Number Displays serial no.
Conguration Displays machine conguration.
Operating Hour Coun-
ter
Displays welding time in hours and min-
utes.
Op. voltages 60/24V Displays voltages in Volt..
Transf. Temperature Displays temperature in °C..
Main menu Level 1
Factory
settings
Range Note
Parameters Spot welding time 1,0 s 0,1...10,0 s Only available in spot
welding mode.
Interval time-Welding 1,0 s 0,1...10,0 s Only available in interval
mode.
Interval time-Wait 0,2 s 0,1...1,0 s
Gas pre-ow 0,1 s 0,0...10,0 s
Wire creep speed 2,0 m/min 1,0...15,0 m/min
Wire burnback time 100 % 0...300 %
Gas post-ow 0,5 s 0,1...20,0 s

LORCH M-Pro Performance Series Specifications

General

Brand	LORCH
Model	M-Pro Performance Series
Category	Welding System
Language	English